Wheel stripes Scooter Swap shop
$ 19.99
These Scooter swap shop wheel stripes are cool little simple products that will set your bike apart from the rest. They fit 10-13 inch wheels. These are made of the highest quality vinyl and Laminated for Uv and abrasive protection.
THIS ALSO COMES WITH A MATCHING SCOOTER SWAP SHOP STICKER!
Comes with 8 stripes total
Colors are listed as outer color, inner color.
Made By Pm Print Lab
Installation instructions:
Apply on a clean bike...
1: Wash your hands
2: Degreaser to clean the application area on the wheel.
3: Clean with Rubbing alcohol.
4: Dry the area
5: Find the center of the wheel
6: Remove the stripe and apply slowly (From the Center), from one end to the other. (take your time) When applying the 2nd stripe find the center of the Opposite side of the wheel. (the same way you installed previously) Then start from that point and repeat (from the center) so it's even with the opposite side There is a gap in-between the stripes on both sides. (Note: these can be pulled up easily if you are a little off.)
7: After all are installed and placed where you would like. Take a hairdryer or heat gun and heat them on the wheel so they are very warm not hot to the touch but close (Do Not burn them). That will activate the adhesive and lock them into place. If you Do not do this they will not stick properly.
There is no warranty on improper installation If they arent sticking the wheel wasn't cleaned properly or you didn't post heat properly.