Products
Zuma Prebug LED Headlights
Sold Out
LED Headlight kits for your 89-01 zuma! These bolt right into your OEM headlight housing! Way brighter than your OEM headlights! Plug and Play!
Zuma prebug lower body fairing
$ 51.49
Here's the last piece to the puzzle to complete your yamaha zuma build. This is the black underbody panel, found on the very bottom of the bike. Fresh and new...
Zuma prebug replacment axle
$ 15.99
Replacement front axle for zuma prebug, not OEM, but OEM fit.
Zuma prebug vertical Nose trim lip
$ 24.99
Freshen up your scoot with a new, crisp gloss black nose trim piece. This is the part that mounts to the bottom of your colored nose section up front.
Zuma prebug vertical throttle cable
Sold Out
Replacement throttle cable for your DISK BRAKE vertical zuma. This will work for stock, and also work with dellorto, polini cp etc. This is only for the first generation, prebug...
Zuma primary drive bearing
$ 8.99
Primary drive bearing (inside the gear cover bearing) Replace this when doing gears for easier install.
Zuma Replacement choke lever
$ 9.99
Replace that old, snapped off choke lever with a fresh replacement! Fits 1989-2001 yamaha zuma, this replaces the OEM choke lever on the left hand control.
Zuma Vertical (89-01) underseat fairing/rear fender
Sold Out
Previous owner of your zuma cut that fender back and not digging the look? We've got you covered with a brand new underside fairing for your prebug! This fairing goes...
Zuma vertical replacement intake manifold
$ 18.99
Replacement intake manifold for your 89-01 zuma vertical
Zuma Vforce3 8 Pedal Race Reed Cage Kit
$ 111.49
Stage6 Reed Valve V-Force 3 is the result of a successful collaboration with Moto Tassinari, renowned US manufacturer of reed valves for Motocross. The unique V-shaped design with double reed...
Zuma woodruff key
$ 7.99
It's always good to replace your woodruff key when you get a new crank, or maybe your existing one sheared off due to improper assembly? Whatever the reason, we offer...
Zuma, jog, minarelli variator nut and conical washer
$ 5.99
Replacement nut and conical washer for your horizontal/vertical minarelli scooter!
Ø8 to Ø10 polini banjo
Sold Out
polini banjo bolt to run a 10mm brake line with a caliper or master that uses a 8mm banjo